The purpose of this guide is to provide detailed product information and trimming instructions for True Temper shafts. Please remember the following general rules when assembling your clubs:

butt trim shafts to finished length after tip trimming unless specified.

Taper tip shafts should never be tip trimmed because they are designed to discrete lengths. butt trim taper tip shafts to finished length Tip trim according to head type (refer to the appropriate chart below).

The finished club lengths listed are for reference only and should not be considered "standard" lengths.

Assembled Club Lengths

Irons

		1	2	3	4	5	6	7	8	9	PW
	Steel	39.75	39.25	38.75	38.25	37.75	37.25	36.75	36.25	35.75	35.5
	Graphite	40.0	39.5	39.0	38.5	38.0	37.5	37.0	36.5	36.0	35.75

Measurements above are represented in inches.


Woods

		Driver	3 - Wood	4 - Wood	5 - Wood	7-9 Wood
	Steel	44.0"	43.0"	42.5"	42.0"	41.0"
	Graphite/BiMatrx	45.0"	44.0"	43.5"	43.0"	42.0"

Clubhead Styles

Through-bore	Blind-bore	Standard-bore
With a through-bore head the shaft is inserted through the entire clubhead.	A blind-bore head usually has a shaft insertion depth of 1 ¼” to 2”.	A standard-bore head usually has a shaft insertion depth of 1” to 1 ¼”.

Click on a link to the right to view product specific trimming information.